Netgear DM111P Bedienungsanleitung PDF herunterladen (Seite 19)

Connecting to the Internet 2-1

v1.1, September 2006

Chapter 2

Connecting to the Internet

This chapter describes the various ways you can connect your DM111P ADSL2+ Ethernet Modem

to the Internet.

Information You Need Before You Begin

Before you attempt to connect to the Internet you will need the information provided by your

Internet Service Provider (ISP) when you opened your account. At a minimum, you will need your

ISP, and other configuration parameters automatically, or it may prompt you for the following

parameters:

• Virtual Path Identifier (VPI)

• Virtual Circuit Identifier (VCI)

• Bridging protocol (PPPoA, PPPoE, or RFC2684)

• Multiplexing method, which may be one of the following:

– VIrtual Circuit (VC) based (usually used by PPPoA protocol)

– Logical Link Control (LLC) based (usually used by PPPoE and RFC2684 protocols)

• Maximum Transmission Unit (MTU) size (usually 1500 bytes)

Connecting to the Internet

If the modem was provided by your ISP or you need assistance with physically connecting your

modem, use the Setup Wizard on the CD to connect to the Internet. If the modem was not provided

by your ISP and you do not need step-by-step assistance with physically connecting it, use the

web-browser-based configuration utility to set up the Internet configuration parameters.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 49 50

Keine Kommentare

Netgear DM111P Bedienungsanleitung Seite 19