Netgear Modem FVS318G Bedienungsanleitung Seite 142

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 222
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 141
ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
5-44 Virtual Private Networking
v1.1, August 2010
8. Set the Time Out Period, in seconds, that the VPN firewall should wait for a response from
the RADIUS server.
9. Set the Maximum Retry Count. This is the number of attempts that the VPN firewall will
make to contact the RADIUS server before giving up.
10. Click Reset to cancel any changes and revert to the previous settings or click Apply to save
the settings.
Assigning IP Addresses to Remote Users (ModeConfig)
To simply the process of connecting remote VPN clients to the VPN firewall, you can use the
ModeConfig screen to assign IP addresses to remote users, including a network access IP address,
subnet mask, and name server addresses from the VPN firewall. Remote users are given IP
addresses available in secured network space so that remote users appear as seamless extensions of
the network.
In the following example, we configured the VPN firewall using ModeConfig, and then
configured a PC running ProSafe VPN Client software using these IP addresses.
NETGEAR ProSafe Gigabit 8 Port VPN Firewall FVS318G
WAN IP address: 172.21.4.1
LAN IP address/subnet: 192.168.2.1/255.255.255.0
NETGEAR ProSafe VPN Client software IP address: 192.168.1.2
Mode Config Operation
After the IKE Phase 1 negotiation is complete, the VPN connection initiator (which is the remote
user with a VPN client) requests the IP configuration settings such as the IP address, subnet mask
and name server addresses. The Mode Config feature will allocate an IP address from the
configured IP address pool and will activate a temporary IPsec policy using the template security
proposal information configured in the Mode Config record. The Mode Config feature allocates an
IP address from the configured IP address pool and activates a temporary IPsec policy, using the
information that is specified in the Traffic Tunnel Security Level section of the Mode Config
record (on the Add Mode Config Record screen that is shown in Figure 5-33 on page 5-46).
Note: Selection of the Authentication Protocol, usually PAP or CHAP, is configured
on the individual IKE policy screens.
Seitenansicht 141
1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 221 222

Kommentare zu diesen Handbüchern

Keine Kommentare