Netgear WG602v3 Bedienungsanleitung PDF herunterladen (Seite 42)

Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3

4-2 Management

202-10060-02, February 2005

This screen shows the following parameters:

Table 4-1. General Information Fields

Field Description

Access Point Information

Access Point Name The default name can be changed if desired.

MAC Address Displays the Media Access Control address (MAC Addresses) of the

wireless access point’s Ethernet port.

Region

Displays the country or region for which the wireless access point is

licensed for use. It may not be legal to operate this wireless access point in

a region other than one of those identified in this field.

Firmware Version The version of the firmware currently installed.

Current IP Settings

These parameters apply to the Local WG602v3 wireless access point.

IP Address The IP address of the wireless access point.

Subnet Mask

The subnet mask for the wireless access point.

Default Gateway

The default gateway for the wireless access point.

DHCP Client Enabled by default. Enabled (DHCP client) indicates that the current IP

address was obtained from a DHCP server on your network.

Wireless Settings

These parameters apply to the target remote WG602v3, VPN gateway, or

VPN client.

Wireless Network Name

(SSID)

Displays the wireless network name (SSID) being used by the wireless port

of the wireless access point. The default is NETGEAR.

Channel Identifies the channel the wireless port is using. 11 is the default channel

setting. See “Wireless Channels” on page B-7 for the frequencies used on

each channel.

Encryption Type

The current encryption setting.

Access Control

Disabled by default.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 121 122

Keine Kommentare

Netgear WG602v3 Bedienungsanleitung Seite 42