Netgear WG602v3 Betriebsanweisung PDF herunterladen (Seite 40)

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual

2-20 Installation and Configuration

v1.0, August 2006

To restrict access based on a MAC address:

1. From under the Setup menu in the left-hand panel, click Access Control. The Access Control

screen will display.

2. Check the Access Control radio button for the type of access control you want to enable.

Access Control is disabled by default:

• Disable

• Allow

•Block

If you selected Allow, then all addresses will be blocked except those added to the MAC

Address list; conversely, if you selected Block, then all addresses are accepted except those

added to the MAC Address List.

3. Enter the MAC Address for the device you want to manage in the MAC address field. (You

can usually find the MAC address printed on the bottom of the device.)

4. Click Add to add each wireless device to the access list. Repeat these steps for each additional

device to be added.

5. Click Apply to save your wireless access control list settings.

Figure 2-16

Tip: You can copy and paste the MAC addresses from the WG602v3’s Station List

table into the MAC Address box. First, configure each wireless PC to obtain a

wireless link to the WG602v3 so that the PC appears in the Station List table.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 75 76

Keine Kommentare

Netgear WG602v3 Betriebsanweisung Seite 40