Netgear Switch M4100 Bedienungsanleitung PDF herunterladen (Seite 365)

100

101

Chapter 19. Switch Stacks | 365

ProSafe M4100 and M7100 Managed Switches

1. Issue the member <unit-id> <switchindex> command. To view the supported unit

types, use the show supported switchtype command.

2. Next, configure the unit you just defined with configuration commands, just as if the unit

were physically present.

Ports for the preconfigured unit come up in a detached state.

3. T

o see the ports, use the show port all command. Now you can configure the detached

ports for VLAN membership and any other port-specific configuration.

After you preconfigure a unit type for a specific unit number, attaching a unit with different unit

type for this unit number causes the switch to report an error

. The show switch command

indicates config mismatch for the new unit and the ports on that unit don’t come up. To

resolve this situation, you can change the unit number of the mismatched unit or delete the

preconfigured unit type using the no member <unit-id> command.

When you add a preconfigured switch to the switch stack, the stack applies either the

preconfigured configuration or the default configuration.

The following table lists the events

that occur when the switch stack compares the preconfigured configuration with the new

switch.

Table 2. Preconfigured Switches Compared to Stack Configuration

Switch Type Is the

Same

Stack Member Number Result

Yes Is the same. The switch stack applies configuration to the

preconfigured new switch and adds it to the stack.

Yes Does not match. • The switch stack applies its default stack member

number to the preconfigured switch and adds it to

the stack.

• The stack member number configuration in the

preconfigured switch changes to reflect the new

information.

Is not found in the stack

configuration.

• The switch stack applies the default configuration

to the new switch and adds it to the stack.

• The preconfigured information is changed to reflect

the new information.

Is not found in the

preconfigured switch.

The switch stack applies the default configuration to

the preconfigured switch and adds it to the stack.

Renumber Stack Members

This example is provided as CLI commands and a Web interface procedure.

1 2 ... 360 361 362 363 364 365 366 367 368 369 370 ... 558 559

Kommentare zu diesen Handbüchern

Keine Kommentare

Netgear Switch M4100 Bedienungsanleitung Seite 365

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Netgear Switch M4100