Netgear WMS5316 Bedienungsanleitung PDF herunterladen (Seite 20)

20 | Chapter 3: Wireless Configuration

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual

Output Power Select the available transmit power of the access point. This option sets the transmit

signal strength of the access point. Increasing the power improves performance, but

if two or more access points are operating in the same area, on the same channel, it

can cause interference.

RTS Threshold (0-2347) The transmission mechanism (CSMA/CA or CSMA/CD) for the packets. If the packet

size is equal to or less than this threshold, then the data frame is transmitted

immediately. However, if the packet size is larger than the specified value, then the

transmitting station must send out an Request to Send Threshold (RTS) packet to the

receiving station, and then must wait for the receiving station to send back a Clear to

Send (CTS) packet before sending the actual packet data.

Fragmentation Length

(256-2346)

The maximum packet size that used for fragmentation of data packets. Packets

larger than the specified fragmentation length are broken up into smaller packets

before being transmitted. The fragmentation length must be an even number.

Beacon Interval

(100-1000)

The time interval for each beacon transmission that allows the access point to

synchronize the wireless network.

Aggregation Length

(1024-65535, 11n only)

The length that defines the maximum length of Aggregated MAC Protocol Data Unit

(AMPDU) packets. Larger aggregation lengths might sometimes lead to better

network performance. Aggregation is a mechanism used to achieve higher

throughput.

AMPDU (11n only) Allow the aggregation of several MAC frames into a single large frame to achieve

higher throughput. Enabling AMPDU can sometimes lead to better network

performance.

RIFS Transmission (11n

only)

Enable the Reduced Interframe Space (RIFS) option to allow transmission of

successive frames at different transmit powers. Enabling RIFS can lead to better

network performance.

Enable Wi-Fi MultiMedia

(WMM)

Select this check box to ensure that applications that require better throughput and

performance are provided special queues with higher priority. For more information

about WMM, see

QoS for Managed Access Points on page 21.

DTIM Interval (1–255) Enter the DTIM or the data beacon rate that you want to use. This sets the message

period of the beacon delivery traffic indication in multiples of beacon intervals.

Preamble Type (11b//jointfilesconvert/34122/bg

only)

A long transmit preamble can provide a more reliable connection or a slightly longer

range. A short transmit preamble gives better performance. The Auto setting

automatically handles both long and short preambles. The default is Auto.

Access Point Channel Each managed access point’s channel and frequency can be individually selected.

The access point mode is set either to the one enabled for the group, or if the

selected mode is not available on the access point, to the mode providing highest

performance.

Table 1. Advanced Wireless Settings (Continued)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare

Netgear WMS5316 Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Netgear WMS5316