Netgear Switch L3 Bedienungsanleitung PDF herunterladen (Seite 184)

7000 Series L3 Managed Switch Reference Manual for Software v2.0

9-6 CLI Commands: Differentiated Services

config diffserv class match dstl4port keyword

This command adds to the specified class definition a match condition based on the destination

layer 4 port of a packet using a single keyword notation. The

<classname> is the name of an

existing DiffServ class. The value for

<portkey> is one of the supported port name keywords

(listed below). The optional [exclude] parameter has the effect of negating this match condition for

the class (i.e., match all destination layer 4 port numbers except for the one specified here).

The currently supported

<portkey> values are: domain, echo, ftp, ftpdata, http, smtp,

snmp, telnet, tftp, www

. Each of these translates into its equivalent port number, which is used

as both the start and end of a port range.

Note: The dstl4port keyword, number, and range commands are alternative ways to specify a

destination layer 4 port range as a match criterion.

Default none

Format config diffserv class match dstl4port keyword <class-

name> <portkey> [exclude]

config diffserv class match dstl4port number

This command adds to the specified class definition a match condition based on the destination

layer 4 port of a packet using a numeric notation. The

<classname> is the name of an existing

DiffServ class. One layer 4 port number is required. The port number is an integer from 0 to

65535. The optional

[exclude] parameter has the effect of negating this match condition for the

class (i.e., match all destination layer 4 port numbers except for the one specified here).

Note: The dstl4port keyword, number, and range commands are alternative ways to specify a

destination layer 4 port range as a match criterion.

Default none

Format config diffserv class match dstl4port number <class-

name> <0-65535> [exclude]

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 270 271

Keine Kommentare

Netgear Switch L3 Bedienungsanleitung Seite 184