Netgear PROSAFE WG302v2 Bedienungsanleitung Seite 96

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 102
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 95
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
C-14 Command Line Reference
v1.0, May 2006
Viewing and Configuring Management Settings
The commands in Table C-12 correspond to the pages on the Web UI under the Management
heading. This section includes commands for the following features:
Change Password
Remote Management
Upgrade Firmware
Backup and Restore
Reboot the System.
Table C-12 AP Management
Task Command
Set a password for admin access
to the AP.
set system password <password>
Enable Remote CLI Access set ssh status up
Disable Remote CLI Access set ssh status down
Enable SNMP set snmp status up
Disable SNMP set snmp status down
Set a Public Community name set snmp ro-community <string>
Set a Private Community name set snmp rw-community <string>
Set an IP address to receive
SNMP traps
set traphost host <ip_address>
Upgrade the firmware (requires a
reboot)
firmware-upgrade <url>
Example:
firmware-upgrade tftp://1.2.3.4/upgrade.tar
firmware-upgrade file://1.2.3.4/tmp/upgrade.tar
Backup the configuration file
config download <url>
Example:
config download tftp://1.2.3.4/
defaultcfg.xml
Restore the configuration file
config upload <url>
Example:
config upload tftp://1.2.3.4/defaultcfg.xml
Revert to factory default settings
factory-reset
Reboot the system reboot
Seitenansicht 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 102

Kommentare zu diesen Handbüchern

Keine Kommentare