Netgear WNDAP360 Bedienungsanleitung PDF herunterladen (Seite 49)

Wireless Configuration and Security

ProSafe Dual Band Wireless-N Access Point WNDAP360

Configure WPA with RADIUS, WPA2 with RADIUS, and WPA & WPA2 with

RADIUS

WPA, WPA2, and WPA & WPA2 security requires RADIUS-based 802.1x authentication, so

you also need to define RADIUS server settings. For information about RADIUS servers, see

Configure RADIUS Server Settings o

n page 51.

The selections that are available from the Da

ta Encryption drop-down list depend on the type

of WPA authentication that you select from the Network Authentication drop-down list and are

shown in the following table.

• WP

A with RADIUS

Figure 21.

• WPA2 with RADIUS

Figure 22.

• WPA & WPA2 with RADIUS

Figure 23.

Table 12. WPA with RADIUS, WPA2 with RADIUS, and WPA & WPA2 with RADIUS Settings

Field Descriptions

TKIP Temporal Key Integrity Protocol (TKIP) is the st

andard encryption method used with WPA. You

can also use TKIP with WPA2.

Note: TKIP provides only legacy (slower) rates

of operation. NETGEAR recommends WPA2

authentication with AES encryption if you want to use the 11n rates and speed.

AES Advanced Encryption Standard

(AES) is the standard encryption method used with WPA2.

Note: Although some wireless clients might support AES

with WPA, the WNDAP360 wireless

access point does not support WPA with AES.

TKIP + AES The TKIP + AES encryption method is supported both for WPA and WPA2. Broadcast packets

use

TKIP. For unicast (point-to-point) transmissions, WPA clients use TKIP, and WPA2 clients

use AES. For the WPA & WPA2 mixed mode, TKIP + AES is the only supported data encryption

method.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 136 137

Keine Kommentare

Netgear WNDAP360 Bedienungsanleitung Seite 49