Netgear WMS5316 Bedienungsanleitung PDF herunterladen (Seite 11)

Getting Started

ProSafe 16 AP Wireless Management System WMS5316

Note: The untagged VLAN check box should be cleared only if the hubs

or switches on your LAN support the VLAN (802.1Q) standard.

Likewise, the untagged VLAN value should be changed only if the

hubs and switches on your LAN support the VLAN (802.1Q)

standard.

Changing either of these values will result in a loss of IP connectivity if the hubs and switches

on your network have not yet been configured with the corresponding VLANs.

Management VLANs are used for managing traffic (Telnet, SNMP, and HTTP) to and from the

wireless management system and managed access points.

Frames belonging to the management VLAN are not given any 802.1Q header when sent

over the trunk. If a port is in a single VLAN, it can be untagged. But if the port needs to be a

member of multiple VLANs, it needs to be tagged.

DHCP Server Settings

The wireless management system can function as a DHCP server. Multiple DHCP server

pools can be added for different VLANs. Click the Configuration tab and select System >

Basic > DHCP Server Settings to display the following screen:

This screen lets you to enable and configure the DHCP server. You can specify the following

information:

• Use VLAN Interface: Select this check box to enable the wireless management system to

provide IP addresses to clients in a specified VLAN.

Note: Selecting the Use VLAN Interface check box allows you to access

the VLAN IP Address and Subnet Mask fields. Select this option if

the DHCP pool being added is only for a particular VLAN.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 69 70

Keine Kommentare

Netgear WMS5316 Bedienungsanleitung Seite 11