Netgear WC9500 Bedienungsanleitung PDF herunterladen (Seite 41)

System Planning and Deployment Scenarios

ProSAFE Wireless Controller WC9500

Scenario Example 3: Advanced Network with Redundancy

The following sample scenario consists of an advanced network with one wireless controller,

one redundant wireless controller, one core switch, two PoE switches in different buildings,

access points, and several VLANs and SSIDs. These are the components in the wireless

controller system:

• One wireless controller

• Fifty access points (managed by the wireless controller through management VLAN 1)

• One redundant wireless controller

• Four VLANs: VLAN 10, VLAN 20, VLAN 30, and VLAN 40

• Three SSIDs: SSID 1, SSID 2, and SSID 3

In this scenario, the VLANs and SSIDs are used to accommodate traffic for different user

groups in a school that is spread out over two buildings.

• Building 1:

- SSID 1 in VLAN 10 for staff traffic

- SSID 2 in VLAN 20 for middle school students

- SSID 3 in VLAN 30 for guests

• Building 2:

- SSID 1 in VLAN 10 for staff traffic

- SSID 2 in VLAN 40 for high school students

8. When the access points are operating, open the Discovery

Wizard to do the following:

Access Point > Discovery Wizard

1. Specify the state of the access points, which is factory default

in a Layer 2 network.

2. Run the Discovery Wizard.

3. Select the access points that you want the wireless controller to

manage and add them to the managed list.

Note: By adding the access points to managed list, you enable

them to receive an IP address from the DHCP server over

management VLAN 100.

9. For each access point on the managed list, disable the untagged

VLAN and configure VLAN 100 as the management VLAN. Doing

so causes the access points to lose connectivity with the wireless

controller.

10. Restore connectivity between the access points and the wireless

controller by changing the PoE switch ports to which the access

points are connected to tagged ports.

During the discovery process, these switch ports were access

ports in management VLAN 100.

Step Configuration Web Management Interface Path

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 356 357

Keine Kommentare

Netgear WC9500 Bedienungsanleitung Seite 41