
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
4-8 Advanced Configuration
v4.0, April 2006
3. Verify the following parameters for all access points:
• Verify that the LAN network configuration the ProSafe 802.11gs are configured to operate
in the same LAN network address range as the LAN devices
• Only one AP is configured in Point-to-Multi-Point Bridge mode, and all the others are in
Point-to-Point Bridge mode.
• All APs must be on the same LAN. That is, all the APs LAN IP address must be in the
same network.
• If using DHCP, all ProSafe 802.11gs should be set to “Obtain an IP address automatically
(DHCP Client)” in the IP Address Source portion of the Basic IP Settings menu.
• All ProSafe 802.11gs use the same SSID, Channel, authentication mode, if any, and
encryption in use.
• All Point-to-Point APs must have the AP2 MAC address in its Remote AP MAC address
field.
4. Verify connectivity across the LANs.
• A computer on any LAN segment should be able to connect to the Internet or share files
and printers with any other PCs or servers connected to any of the three LAN segments.
• Wireless stations will not be able to connect to the ProSafe 802.11gs in the illustration
above. If you require wireless stations to access any LAN segment, you can add additional
ProSafe 802.11gs configured in Wireless Access Point mode to any LAN segment.
Figure 4-6.
'Master' AP in
Point-to-Multi-Point
Bridge Mode
LAN
Segment 1
192.168.0.1
Router
AP in
Point-to-Point
Bridge Mode
Hub or Switch
LAN
Segment 3
AP in
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
ETHERNET
RESET
5-12VDC
AP3
ETHERNET
RESET
5-12VDC
AP2
ETHERNET
RESET
5-12VDC
Kommentare zu diesen Handbüchern