
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
A-2 Factory Defaults and Technical Specifications
v4.0, April 2006
Time Zone Adjusted for Daylight Saving
Time
Disabled
SNMP Enabled, but Trap forwarding disabled
Spanning Tree Protocol Enabled
Secure Telnet Enabled
Wireless
Operating Mode Access Point
Access Point Name
netgearxxxxxx where xxxxxx are the last 6 digits of the
wireless access point MAC address.
Wireless Communication Enabled
Wireless Network Name (SSID) NETGEAR
Broadcast Network Name SSID Enabled
Security Disabled
Transmission Speed Auto
a
Country/Region United States (in North America; otherwise, varies by
region)
80211.g Radio Frequency Channel 11 until the region is selected
VLAN(802.1Q)
Disabled
Output Power
Full
Wireless Card Access List All wireless stations allowed
WMM Support Disabled
SuperG Mode Disabled
a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will
vary. Network conditions and environmental factors, including volume of network traffic, building materials
and construction, and network overhead, lower actual data throughput rate.
Table A-1. Access Point Default Configuration Settings
Feature Description
Kommentare zu diesen Handbüchern