Netgear WC7600 Bedienungsanleitung PDF herunterladen (Seite 129)

Discover and Manage Access Points

129

ProSAFE Wireless Controller WC7600

The screen adjusts to display a third set of Start IP and End IP fields.

d. In the Range 3 section, fill in the Start IP and End IP fields.

9. Click the Next button.

The Discovery Wizard Step 3 of 3 : Select Access Points to manage screen displays.

The wireless controller searches for NETGEAR products on the LAN based on MAC

address and then identifies which products are supported access point models. A

progress bar show the progress of the discovery process.

When the discovery process is finished, the total number of access points is displayed

and the table shows the access points that were discovered. For each access point, the

table includes the model number

, IP address, MAC address, and site.

10. T

o find an individual access point, enter information in the Search field.

11. T

o make sure that all the access points are listed, review the discovery results.

The effectiveness of the discovery process depends in part on how the access points on

your LAN are set up. If each access point is configured with a unique IP address and is

running current firmware, discovery is simple.

If the discovery results are not what you expect, check the following:

• Access points that the wireless controller already manages are not in the discovery

list.

To view the Managed AP List, select Access Point > Managed

AP List.

• Make sure that a DHCP server is available in the network or on the wireless

controller.

For information about the wireless controller’s DHCP server, see Manage the DHCP

Server on page 65.

• If more than one access point has the same IP address, only one of them is

discovered at a time.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 306 307

Keine Kommentare

Netgear WC7600 Bedienungsanleitung Seite 129