Netgear WNDAP380Rv2 Bedienungsanleitung PDF herunterladen (Seite 96)

Advanced Configuration

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

Network Authentication

and Data Encryption

(continued)

Open System Although you can use the bridge communication without any

authentication and encryption, NETGEAR recommends that

you use WEP if you do select an open system. From the

Data Encryption drop-down menu, select one of the

following:

• None. No authentication and encryption.

• 64-bit WEP. Standard WEP encryption, using 40/64-bit

encryption.

• 128-bit WEP. Standard WEP encryption, using

104/128-bit encryption.

• 152-bit WEP. Proprietary WEP encryption mode, using

128+24 bit encryption.

This mode functions only with

other access points that support this mode.

o configure WEP:

1. In the passphrase field, enter a passphrase.

2. Click Generate.

The key is generated and placed in the WEP Key field.

WPA-PSK TKIP (Temporal Key Integrity Protocol) is the standard

encryption method used with WP

A-PSK and the only

selection possible from the Data Encryption drop-down

menu.

In the WPA Passphrase (Network Key) field, enter a

passphrase. The passphrase length needs to be between

8 and 63 characters (inclusive).

A2-PSK AES (Advanced Encryption Standard) is the standard

encryption method used with WP

A2-PSK and the only

selection possible from the Data Encryption drop-down

menu.

In the WP

A Passphrase (Network Key) field, enter a

passphrase. The passphrase length needs to be between

8 and 63 characters (inclusive).

Note:

If you want to use the 11n rates and speed,

NETGEAR recommends WPA2-PSK authentication with

AES encryption.

Link Test

The link test lets you validate the bridge configuration by testing whether an IP address behind the

remote access point is reachable.

IP Address Enter an IP address that can be reached through the remote access point for

which you are setting up a bridge configuration. Click Link T

est.

Link T

est Process

Status

After one minute or less, the link test returns one of the following results:

• Success. The

link

can be established using the bridge configuration, and

the IP address behind the remote access point is reachable. You can

click Apply to save the bridge configuration.

• Failure. The link cannot be established using the bridge configuration.

Either the remote access point is not configured correctly or the IP

address behind the remote access point is reachable.

Setting Description

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 151 152

Kommentare zu diesen Handbüchern

Keine Kommentare

Netgear WNDAP380Rv2 Bedienungsanleitung Seite 96

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für WLAN-Zugangspunkte Netgear WNDAP380Rv2